crwdns2933803:06crwdne2933803:0
crwdns2933797:0PedroDaGr8crwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 PedroDaGr8
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove the motor support brackets |
|---|---|
| + | [* black] There are two motor support brackets: one in front, one back (shown in the first picture) |
| + | [* black] Using a #2 Phillips screwdriver, remove the four screws (circled in yellow in the second and third pictures) which attach the two motor support brackets. |
| + | [* black] Each bracket is attached to the motor by two screws (one on each side). |
| + | [* black] Take care to place your hand under the support bracket when removing the second screw as they will fall out and could damage the finish. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0