crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Miroslav Djuriccrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] I'm simulating screwing on the throttle to the carburetor by compressing the gold cylinder against the grey cap. As you can see, the spring compresses, and the throttle cable pops outward.
-[* black] When I pull on the actual throttle, the throttle cable goes inwards. I believe this is the desired action -- what the cable is supposed to do.
+[* black] I'm simulating screwing on the throttle to the carburetor by compressing the gold cylinder against the gray cap. As you can see, the spring compresses, and the throttle cable pops outward.
+[* black] When I twist the moped's throttle, the throttle cable goes inwards. I believe this is the desired action for the cable.
[* black] There are two problems, however:
- [* black] There's no force that pushes the throttle cable back out (essentially for it to spring back like it did)
+ [* black] Nothing pushes the throttle cable back out when I release the moped's throttle.
[* black] The throttle needle does not move, but to my understanding it should go upward when I apply the throttle.
[* black] Please check out my Answers question if you can help me solve this problem! Thanks a lot!