crwdns2933803:06crwdne2933803:0
crwdns2933797:0Miroslav Djuriccrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] I'm simulating screwing on the throttle to the carburetor by compressing the gold cylinder against the grey cap. As you can see, the spring compresses, and the throttle cable pops outward. |
|---|---|
| + | [* black] When I pull on the actual throttle, the throttle cable goes inwards. I believe this is the desired action -- what the cable is supposed to do. |
| + | [* black] There are two problems, however: |
| + | [* black] There's no force that pushes the throttle cable back out (essentially for it to spring back like it did) |
| + | [* black] The throttle needle does not move, but to my understanding it should go upward when I apply the throttle. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0