crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933805:0crwdne2933805:0

crwdns2933797:0Spencer Daycrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Day

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* icon_caution] Take care not to puncture or bend the battery with your tools—a punctured or bent battery may leak dangerous chemicals or cause a thermal event.
-[* black] Slide a plastic card underneath the far left battery cell group to slice through the adhesive holding it to the case.
- [* icon_note] If you encounter significant resistance at any point during this procedure, pause and apply more adhesive remover. Wait for it to soak into the adhesive, and try again.
-[* black] Wiggle the card from side to side as you insert it under the battery cells to fully separate all adhesive holding them in place.
-[* black] Leave the plastic card temporarily underneath the cell to prevent it from re-adhering while you continue.
+[* icon_note] If you encounter significant resistance at any point during this procedure, apply more isopropyl alcohol, wait one minute, and try again.
+[* black] Slide a plastic card underneath the left battery cell group.
+[* black] Slide the card back and forth under the battery cells to slice the adhesive securing them.
+[* black] Leave the plastic card underneath the battery to prevent it from re-adhering.