crwdns2933803:02crwdne2933803:0
crwdns2933797:0Spencer Daycrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Day
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Unfasten the MagSafe port | |
| [* red] Use a T3 Torx driver to remove the two 3.3 mm screws securing the metal wedge to the MagSafe port. | |
| [* icon_note] This wedge keeps the port secure in its recess. | |
| [* orange] Use a T5 Torx driver to remove the two 2.8 mm screws securing the MagSafe port to the frame. | |
| - | [* icon_reminder] During reassembly: |
| - | [* icon_note] The screws will be drawn toward the magnet in the MagSafe port. You may need to use angled tweezers to hold the screws in place while tightening them. |
| - | [* orange] First, partially tighten the 2.8 mm‑long screws that secure the MagSafe port. Then, adjust the port so it's properly aligned. Finally, fully tighten the screws. |
| - | [* icon_note] You can plug your charger in and use it to align the port, but ***make sure it's not plugged into power***. |
| - | [* red] Next, secure the wedge by partially tightening its two 3.3 mm‑long screws. Push the wedge under the lip of the frame and hold it in position. Finally, fully tighten the screws. |