crwdns2933803:014crwdne2933803:0
crwdns2933797:0iRobotcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 iRobot
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Reassembly information | |
| [* icon_note] Your 3.0 mm nut driver may be too long to thread the hex head screw in. Use one of the following techniques to begin threading the screw in: | |
| [* black] Thread the screw in using your fingertips. | |
| - | [* black] Thread the screw in using blunt nose tweezers. |
| + | [* black] Thread the screw in using blunt nose [product|IF145-020|tweezers]. |
| [* black] Use your T3 Torx driver to [link|https://guide-images.cdn.ifixit.com/igi/pHUWbSOvyfPyVRut.full|install the 1.4 mm screw|new_window=true] into the hex head screw. Then, install the hex head screw using the T3 Torx driver. Finally, hold the hex head screw while you [link|https://guide-images.cdn.ifixit.com/igi/HaKEhKdonwCxNbXT.full|remove the 1.4 mm screw|new_window=true]. | |
| [* black] Once the hex head screw is threaded in a few turns, tighten it using your nut driver. |