crwdns2936039:0How to Remove the Logic Board and Heatsinkcrwdnd2936039:014crwdne2936039:0

crwdns2933803:014crwdne2933803:0

crwdns2933797:0Clay Eickemeyercrwdnd2933797:0N'w 28, 2022crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Clay Eickemeyer

	[title] Reassembly information
-	[* icon_note] Your 3.0 mm nut driver may be too long to thread the hex head screw ~~into the top left of the logic board~~. Use one of the following ~~methods~~ to begin threading the screw in:
+	[* icon_note] Your 3.0 mm nut driver may be too long to thread the hex head screw in. Use one of the following techniques to begin threading the screw in:
	[* black] Thread the screw in using your fingertips.
	[* black] Thread the screw in using blunt nose tweezers.
	[* black] Use your T3 Torx driver to [link\|https://guide-images.cdn.ifixit.com/igi/pHUWbSOvyfPyVRut.full\|install the 1.4 mm screw\|new_window=true] into the hex head screw. Then, install the hex head screw using the T3 Torx driver. Finally, hold the hex head screw while you remove the 1.4 mm screw.
-	[* black] Once the hex head screw is threaded in by a few turns, tighten it using your nut driver.
+	[* black] Once the hex head screw is threaded in at least a few turns, tighten it using your nut driver.