crwdns2933803:01crwdne2933803:0
crwdns2933797:0Cyrus Foxcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Cyrus Fox
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Breaching the water proof seal ≈2.5mm | |
| [* red] To open device use spudger/Credit card, and start on either the upper Right or lower right and first Free the right side. | |
| - | [* black] The screen is held on by 2.5mm of adhesive throughout, Check out third picture |
| + | [* black] The screen is held on by 2.5mm of adhesive throughout, Check out third picture with the screen removed to see adhesive strips. |
| [* green] Watch out for backlight and data cable located in upper left behind screen. | |
| [* red] Run spudger/card through Right Side, Top and bottom, then pry screen open. | |
| - | [* light_blue] 3 Connections we need to remove, you remove the cable by pulling up on the black bar, this frees the ribbon cable. From top to bootm the cables are backlight, screen, & touch. |
| - | [* red] After removing 3 ribbon cables, partial close screen and finish freeing the last left side of the screen |
| + | [* light_blue] 3 Connections need to be removed. Remove ribbon cable by pulling up on the black bar from the opposite side, this frees the ribbon cable. |
| + | [* light_blue] From top to bottom the cables are backlight, screen, & touch. Pretty cool to see the display locked on last image after you remove the screen cable. Consider converting to art hanged e-ink display before junking in the future :) |
| + | [* red] After removing 3 ribbon cables, partially close screen and finish freeing the last left side of the screen from the adhesive strip. After free screen will pull off. |