crwdns2933803:01crwdne2933803:0
crwdns2933797:0Cyrus Foxcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Cyrus Fox
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Breaching the water proof seal ≈2.5mm |
|---|---|
| + | [* red] To open device use spudger/Credit card. Begin opening by freeing the right side, starting either the upper right or lower right side. |
| + | [* black] The screen is held on by 2.5mm of adhesive throughout, Check out third picture with the screen removed to see adhesive strips. |
| + | [* green] Watch out for backlight and data cable located in upper left behind screen. |
| + | [* red] Run spudger/card through Right Side, Top Side and Bottom side. After you have cleared these, pry screen open with the left side acting like a hinge.. |
| + | [* light_blue] With the device partially open, 3 Connections need to be removed. Remove the ribbon cables by pulling up on the black bar from the opposite side, this frees the ribbon cable. |
| + | [* light_blue] From top to bottom the cables are backlight, screen, & touch. Pretty cool to see the display locked on last image after you remove the screen cable. Consider converting to art hanged e-ink display before junking in the future :) |
| + | [* red] After removing 3 ribbon cables, partially close screen and finish freeing the last left side of the screen from the adhesive strip. After free screen will pull off. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0