crwdns2933803:014crwdne2933803:0
crwdns2933797:0Ian Glencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ian Glen
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [title] Check Rod Bearing Clearances |
|---|---|
| - | [* black] Insert wisdom here. |
| + | [* icon_note] This step is for two-bolt turbo engines only. |
| + | [* red] Install the four girdle side stays. |
| + | [* orange] One stay is shaped differently and goes in the front-right position. |
| + | [* yellow] Install the eight side stay bolts. Apply engine oil to the threads and underneath the bolt head. |
| + | [* icon_caution] Do not dip the entire bolt in engine oil. This may damage the block. |
| + | [* black] Use a 14mm wrench to snug all bolts. |
| + | [* black] Use a torque wrench and 14mm socket to tighten the girdle-side bolts, followed by the block-side bolts. |
| + | [* icon_note] The torque is 35 ft-lbs (48 Nm). |