crwdns2933803:06crwdne2933803:0
crwdns2933797:0Ian Glencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ian Glen
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [title] Crankshaft and Main Bearings |
|---|---|
| - | [* black] Install main bearing halves in the block and girdle. |
| - | [* icon_note] Make sure the journal surface underneath is clean and dry. |
| - | [* black] Install crankshaft. |
| - | [* black] Add a small piece of Plastigauge to each bearing journal. |
| - | [* black] Install the girdle. |
| + | [title] Crankshaft |
| + | [* black] Install the main bearings into the block and girdle. |
| + | [* icon_note] Install the grooved bearings in the block side. |
| + | [* icon_note] Make sure the journal surfaces underneath are clean and dry. |
| + | [* black] Apply assembly lube to the smooth side of the thrust washers. |
| + | [* black] Stick the thrust washers onto the sides of the #3 journal on the block and girdle. |
| + | [* icon_note] The thrust washer grooves face away from the bearing journals. |