crwdns2933803:05crwdne2933803:0
crwdns2933797:0Aayma Mughalcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Aayma Mughal
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Plug in and allow the soldering iron to heat up to approximately 350°C. | |
| [* black] Begin prep of the replacement cable and wires by using a wire stripper or pliers to remove approximately 0.5 inches of the plastic insulation. | |
| [* black] Strip the hot and neutral wires belonging to the unit. In this model, the hot wires are black and red and the neutral wire is white. | |
| [* black] Strip the wires belonging to the replacement cable. | |
| - | [* icon_note] The power cable for this model does not utilize the ground wire. If the replacement cable contains a ground wire, tape around the exposed wire using electrical tape. |
| [* black] Feed the replacement cable through the entry point at the back of the unit. If it does not fit, the rubber insulation can be stripped further using a utility knife. |