crwdns2933803:01crwdne2933803:0
crwdns2933797:0Alex Diaz-Kokaislcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alex Diaz-Kokaisl
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Separate the screen | |
| - | [* black] Separate the screen from the phone assembly. |
| - | [* icon_reminder] During reassembly, apply new adhesive where it's necessary after cleaning the relevant areas with isopropyl alcohol (>90%). |
| + | [* black] Remove the screen. |
| + | [* icon_reminder] During reassembly: |
| + | [* black] This is a good point to test your phone before sealing it up. Temporarily connect your screen, power on your phone, and make sure it works as expected. Before continuing with reassembly, ***power off your phone and disconnect the screen***. |
| [* black] [guide|156204|Follow this guide|new_window=true] if you're using custom-cut adhesives for your device. | |
| [* black] [guide|113604|Follow this guide|new_window=true] in case you're using a pre-cut adhesive card. | |
| - | [* black] Perform a [link|https://pixelrepair.withgoogle.com/udfps|fingerprint sensor calibration|new_window=true] |
| - | [* icon_reminder] If your replacement screen's display cable is held down by tape, remove the tape before installation. |
| - | [* icon_reminder] Be sure to remove all adhesive liners from your replacement screen. ***Check the selfie camera recess and make sure you've removed the liner there.*** |
| - | [* icon_reminder] During the boot-up process after reassembly, the screen will go through a calibration sequence. Do not touch the screen during this process, as it could result in improper touch calibration and create touch issues. |
| + | [* black] If you're installing a new screen, follow [guide|166753|this guide|new_window=true] to calibrate the fingerprint sensor. |