crwdns2933803:01crwdne2933803:0
crwdns2933797:0Joey Burgoscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Joey Burgos
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Turn off device and turn upside-down, exposing the bottom panel of the device. Remove battery by pushing slide tabs towards the middle. | |
| [* black] Turn device back on to its upright position. Long-press the power button ensuring the device is drained of power. Then close and turn back to open bottom panel. | |
| - | [* |
| + | [* red] Remove the screws around the bottom panel, Use a Phillips #1 screwdriver (PH1 bit) to remove the two 12.5 mm screws, four 5.5 mm screws, and six 7.25 mm screws and set aside. |
| [* black] Note: Write down or label where each screw goes to which hole. | |
| - | [* |
| - | [* |
| + | [* red] Remove 2 corner panels along the ends of the battery slot and this will expose another set of screws (1 each under each panel). |
| + | [* red] Remove the remaining six 7.25 mm screws hidden in the battery area and underneath the covers. |