crwdns2933803:01crwdne2933803:0
crwdns2933797:0Joey Burgoscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Joey Burgos
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Turn off device and turn upside-down, exposing the bottom panel of the device. Remove battery by pushing slide tabs towards the middle. This will unlock and unclip the battery from the device, then put aside. | |
| [* black] Turn device back on to its upright position. Long-press the power button ensuring the device is drained of power. Then close and turn back to open bottom panel. | |
| - | [* black] Remove the screws around the bottom panel, Use a Phillips #1 screwdriver (PH1 bit) to remove the two 12.5 mm screws, four 5.5 mm screws, and six 7.25 mm screws and set aside |
| + | [* black] Remove the screws around the bottom panel, Use a Phillips #1 screwdriver (PH1 bit) to remove the two 12.5 mm screws, four 5.5 mm screws, and six 7.25 mm screws and set aside in a bowl or container, and take notes as to where each screw goes to which hole. |
| [* black] Remove 2 corner panels along the ends of the battery slot and this will expose another set of screws (1 each under each panel). Remove the remaining six 7.25 mm screws hidden in the battery area and underneath the covers. |