crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Sarah Westbergcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sarah Westberg

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Lay the tool on its side so that the grey and orange warning labels are pointing upwards. The head and battery base of the tool should point toward you.
- [* red] Use the j1 bit on the end of the 4mm aluminum bit driver to remove the 10 screws holding the tool together.
+[* black] Lay the tool on its side so that the grey and orange warning labels are facing up upwards.
+[* red] Use the JIS #1 screwdriver to remove the 10 screws holding the tool together.