crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:08crwdne2933803:0

crwdns2933797:0Clay Eickemeyercrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Clay Eickemeyer

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Pry and cut the adhesive
[* black] Pull up on the suction cup with a strong, steady force.
- [* icon_note] Significant prying force may be required. Avoid bending or shattering the display.
[* black] Angle the opening pick to about 30 degrees and firmly slide the it toward the right corner of the display.
- [* icon_caution] The force required to separate the adhesive may break your opening pick. Be careful not to slip and cut your fingers during this step.
+ [* icon_caution] This step requires significant force. Hold the pick securely to avoid breaking it or slipping out of the display.
[* icon_note] Be mindful of the angle of your pick. If it is steeper than 30 degrees, it may slip and separate the bezel from the frame.
+ [* black] Slice the adhesive securing the top edge of the display panel.
+[* icon_note] If the adhesive does not separate after a few attempts, apply more heat and repeat the process.