crwdns2933803:02crwdne2933803:0
crwdns2933797:0Alex Zapatacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alex Zapata
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] You’ll need two 4 mm Aluminum Bit Drivers, one with the nut driver 5.5mm bit and the other with a 3mm hex bit. - |
|---|---|
| + | [* black] Place the nut driver bit on the hex nut, (which is on the side of the tool with the orange and gray warning label) and place the 3mm hex bit inside the bolt of the screw opposite of the hex nut. (On the side of the Porter-Cable black design with the red and white star logo) |
| + | [* black] This part will need a bit of muscle, you’ll need to turn the 2 screwdrivers against each other to get a stubborn hex nut off of the screw holding the tool together. |