crwdns2933803:01crwdne2933803:0
crwdns2933797:0Carsten Frauenheimcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Carsten Frauenheim
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [title] Heat the mouse feet |
|---|---|
| - | [* icon_note] If you're planning to reuse your mouse feet, you'll need to thoroughly heat them for a clean removal. |
| - | [* black] Power off your mouse and turn it over. |
| - | [* black] [guide|25705|Heat an iOpener|new_window=true] and apply it to the bottom of the mouse for two minutes. |
| - | [* icon_note] A [guide|157348|hair dryer|new_window=true] may also be used, but be careful not to overheat the mouse—the plastic body may warp or melt. |
| + | [title] Soften the mouse feet adhesive |
| + | [* black] Flip the mouse's power switch into the ***OFF*** position, unplug any cables, and flip it over so the feet are facing up. |
| + | [* icon_note] The unique shape of some mice can prevent them from laying flat. If you need to, [link|https://guide-images.cdn.ifixit.com/igi/BytXBWKtJ4fUWdvr.full?pk_vid=2c78e44ba1c599721683052131449c03|lay your mouse on a soft towel|new_window=true] to prevent wobble. |
| + | [* icon_note] If you're planning to reuse your existing mouse feet, note that the adhesive needs to be thoroughly heated for them to be cleanly removed. |
| + | [* black] [guide|25705|Heat an iOpener|new_window=true] and apply it to the bottom of the mouse for about two minutes. |
| + | [* icon_note] Alternatively, you can use a [guide|157348|hair dryer|new_window=true] to soften the mouse feet adhesive. |
| + | [* icon_caution] When using a hair dryer, don't heat the feet for more than a couple seconds at a time—anything hotter than just warm to the touch risks melting or warping the plastic lower case. |