crwdns2933803:05crwdne2933803:0
crwdns2933797:0Bridgetown Electronics Repaircrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bridgetown Electronics Repair
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Filling Gaps and Refinishing Surfaces |
|---|---|
| [* black] In my case there was quite a bit of damage to the housing that was not only visible, but also would allow things like sand and pocket lint into the device internals. | |
| [* black] To address this, I mixed up a small amount of modeling epoxy and filled in those spots after the seam adhesive had set fully. Then I took a medium grit piece of sandpaper and smoothed out the surface of the epoxy. Finally I used a very high grit piece of sandpaper to blend the plastic surface in with the filler epoxy. | |
| [* black] This strategy didn't result in a perfect finish (this picture is a stock photo used purely as a reference) but I am confident that on a technical level it has been restored to the same level of protection for internal components. |