crwdns2933803:03crwdne2933803:0
crwdns2933797:0Andrew Bookholtcrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* icon_note] This step is only required if you have a |
|---|---|
| + | [* icon_note] This step is only required if you have an anti-glare display. If you have a glossy display, skip to step 12. |
| [* black] Disconnect the Bluetooth cable by pulling the male end straight away from its socket. | |
| [* icon_caution] Pull the connector parallel to the face of the logic board, not straight up. | |
| - | [* black] Use the flat end of a spudger to pry the |
| + | [* black] Use the flat end of a spudger to pry the Bluetooth antenna cable from its socket on the board. |