crwdns2933803:01crwdne2933803:0
crwdns2933797:0knipwimcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 knipwim
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] remove the head |
|---|---|
| + | [* icon_caution] Make sure the drill press is turned off and the power cord is unplugged. |
| + | [* yellow] Loosen tension set screws (on both sides) and make sure tension pulling handle is pushed left. |
| + | [* red] With the 4mm hex key, loosen the set screws holding the head in place on the column. |
| + | [* orange] Remove the vertical adjustment handles to prevent them from damaging when removing the head. |
| + | [* black] Pick up the head from the column and lay it on a table with the on/off buttons facing up. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0