crwdns2933803:04crwdne2933803:0
crwdns2933797:0Sam Gustafsoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam Gustafson
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Install new motor gear | |
| [* red] Pull off the old gear. | |
| [* black] Press the new gear on until about 1 mm of the shaft extends past the end. | |
| + | [* icon_note] If it is too difficult to press on, use a soldering iron to heat the brass gear. A small amount of thermal expansion should make it easier. |