crwdns2933423:0crwdne2933423:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0AJ Pereiracrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 AJ Pereira

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

+[title] Setting endstop position
+[* blue] Use M3x12 BHCS to adjust the endstop position, so the nozzle tip is even with the front edge of the bed when the end stop is triggered
+[* green] Check the clearance between the motor and the linear adaptor. When the bed is all the way back against the endstop. There should be a 1-2 mm gap when the endstop is triggered.

crwdns2933777:01crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0

crwdns2933777:02crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0