crwdns2933803:05crwdne2933803:0
crwdns2933797:0Sam Goldheartcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam Goldheart
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* icon_note] These shots show how the rubber fan gasket should be installed during reassembly. Be sure not to install the gasket underneath the ear where the end of the heatsink is screwed down to the upper case. |
|---|---|
| - | [* icon_note] Additionally, be sure the small post molded into the rubber gasket mates with the hole cut into the upper right corner of the logic board. |
| + | [* icon_reminder] When reassembling your device, attach the gasket to the heat sink as shown. |
| + | [* icon_note] The tail of the gasket should fit into the notch in the heat sink, it should not end up underneath the heat sink tab that will rest on the logic board. |
| + | [* icon_note] Be sure the small post molded into the rubber gasket mates with the hole cut into the upper right corner of the logic board. |