crwdns2933803:02crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] X Axis Disassembly |
|---|---|
| + | [* black] Remove the belt by unhooking it from the bottom if the X carriage plate and pulling it out. |
| + | [* black] To gain access to the M3 screws for the X stepper remove the QR sticker. |
| + | [* black] Remove the 4x M3 countersunk screws using a 2mm allen wrench. Remove the X stepper cover and stepper motor. |
| + | [* black] Disconnect the stepper motor and endstop cables. |
| + | [* black] Remove the X carriage plate by using a 10mm wrench to loosen the eccentric nut on the bottom of plate and slide it off the 2020 extrusion |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0