crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:08crwdne2933803:0

crwdns2933797:0Justin Castlecrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Justin Castle

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[title] Right Side
-[* black] Insert a new Opening Pick just below the one in the corner, and work your way slowly down the right side of the device.
-[* black] Be extra careful of the magnets on this side (see step 6). They will likely stick to the adhesive on the digitizer and will get in the way, making this side more difficult.
+[title] Separate the Digitizer (2)
+[* black] In the same manner as before, use a new opening pick to separate the bottom of the display going from right to left.
+[* black] Leave the pick in the bottom left corner and insert a new pick to slice through the adhesive on the left hand side.
[* black] If at any time the adhesive is too hard, stop and apply more heat.
-[* black] When you reach the corner, leave the Opening Pick there to prevent the adhesive from resealing.
+[* black] When you reach the top left corner, leave the Opening Pick there to prevent the adhesive from resealing.
+ [* black] You should now have 4 opening picks, one in each corner, holding the display separate from the frame, and only adhesive on the top edge.