crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Justin Castlecrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Justin Castle

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Remove the Back Cover
-[* black] Remove the back cover. Starting at a bottom corner, use your iFixIt Opening Tool to remove the back case from the device. Release the bottom first, and release the sides evenly towards the top. Go slowly and make sure to release all the clips.
+[* black] Starting on the left side near the top, insert your Opening Tool in the crack between the case and the bezel. Be careful not to insert into the crack between the screen glass and the bezel.
[* black] In a pinch, a strong fingernail will do instead of the Opening Tool.
-[* black] There are no cables or wires connecting the back, but be careful around the top of the device. All the buttons and connections are there with minimal protection, and can easily be damaged during this step.
+[* black] Work your way down towards the bottom, around the corner, across the bottom to the other corner. Use an Opening Pick to prevent the tabs from snapping back together if needed.
+[* black] Once the second corner is released, the right side should fall off fairly easily. If not, work your way up like the first side.
+[* black] Lift the back cover off, tilting towards the top as if it was a hinge. There are no cables or wires connecting the back, but be careful around the top of the device. All the buttons and connections are on this edge and lifting this edge up could damage them.