crwdns2933803:010crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] For UART and USB Connected Boards | |
| - | [* black] Power off the RPI and SKR3. Copy firmware.bin to a SD. I used a 128mb one I had laying around |
| - | [* black] Insert the SD card into the SKR3. |
| - | [* red] Place a jumper on the VUSB pins |
| - | [* orange] Connect a USB cable from your PC to the SKR3. The status light should light up for 1-2 seconds and go out. Disconnect the USB cable and remove the SD card from the SKR3 and re-insert it into your PC. |
| + | [* red] Make sure the jumper is on the VUSB pins |
| + | [* orange] Power on the SKR3. The status light should light up for 1-2 seconds and go out. Disconnect the USB cable and remove the SD card from the SKR3 and re-insert it into your PC. |
| [* black] The firmware has been uploaded if you see that "firmware.bin" has been renamed to "FIRWMARE.CUR". |