crwdns2933803:02crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Connect your Raspberry Pi to the SKR3 EZ by USB or UART cable. I used a UART cable so that is what I will be showing but I'll try to explain how to setup USB as well. |
|---|---|
| + | [* black] UART wiring |
| + | [* red] PA10 > GPIO15 |
| + | [* blue] PA9 > GPIO14 |
| + | [* green] GND > GND |
| + | [* violet] ***For USB ONLY*** connect a USB cable from the SKR3 EZ to the RPI and place a jumper on VUSB |
| + | [* yellow] Make sure the double throw switch is in the up position |
| + | [* black] Connect the RPI to it's 5v power supply and power it on. Do not power on the the 24v PSU |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0