crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:023crwdne2933803:0

crwdns2933797:0Chayton Rittercrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Chayton Ritter

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* icon_caution] In the following step you'll be very carefully prying up the logic board. The place to lift it is very tight. Avoid damage to the bottom interconnect board by making sure you are not prying against it.
-[* black] Insert the flat end of your spudger between the logic board and the frame of the iPad.
+[* black] Insert the flat end of your spudger between the Logic Board and the bottom interconnect board.
+ [* icon_caution] Do not pry against the bottom interconnect board as this could damage it.
[* black] Use your spudger to slowly pry up the bottom of the Logic Board.
- [* icon_note] If the adhesive is still too strong to pry up the Logic Board, apply some additional solvent and give it time to penetrate.
+ [* icon_note] If the adhesive is still too strong to pry up the Logic Board, apply some additional isopropyl alcohol and wait one minute.
[* black] Lift up the Logic Board and replace the playing card battery blocker with an opening pick.