crwdns2933803:02crwdne2933803:0
crwdns2933797:0Zephoskcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Zephosk
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* icon_caution] This step involve handling sensitive electronics. Avoid static discharge. | |
| [* black] Pull up on the plastic outer barrel that covers the back of the lens (there are no screws holding this part on). | |
| [* icon_caution] Caution, there is a ribbon cable that connects this part to the main PCB board, so be gentle when removing the outer barrel. | |
| - | [* red] The |
| + | [* red] The two ribbon cables plugged into the brown and beige connector are locked in. You must gently lift the locking flap up before you can remove the cables. |
| [* icon_note] [guide|25629|iFixit connector guide|stepid=64969|new_window=true] | |
| [* black] Gently unplug the remaining four ribbon cables from the main PCB board. | |
| [* black] Remove the one screw holding the PCB board to the lens and set it to the side. |