crwdns2933423:0crwdne2933423:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Magnetikcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Magnetik

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

+[title] Remove the display
+[* black] As mentioned before, display is glued in. Heating it up to soften the glue is recommended. You can use dedicated heat plate, hair dryer, heat gun on low power or 3D printers heat bed.I went for the last option, because of even heat distribution and regulated temperature - set to 60 C.
+[* black] When display is heated up, insert a prying tool between the display and case perimeter - top part is recommended to start, because screen PCB is located on the bottom.
+[* black] Unplug the display flex cable and remove the display.

crwdns2933777:01crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0