crwdns2933803:010crwdne2933803:0
crwdns2933797:0♪♫KILLBILLY♫♪crwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 ♪♫KILLBILLY♫♪
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Unhooking the Sub-assembly | |
| - | [* black] Red arrows: screws |
| + | [* black] Red arrows: screws - the screw holding the harness-guide in place is accessed from the front of the machine. |
| [* black] Green arrows: unplug/disconnect | |
| [* black] Purple circle: clip the zip tie | |
| [* black] Green circle: next photo | |
| [* black] Yellow arrows: flow sensors - they unclip from the housing or if you rather don't want to - they also have small connectors that you can unplug. | |
| [* black] Light Blue circle: pull the pipes out from the housing - it is quite hard, but slow and steady wins the race. Wiggling helps too. | |
| [* black] Dark Blue circles: undo the clips using pliers. I just moved the clips about an inch up the hose, easy storage spot. Then just wiggle the hoses off. | |
| [* black] Carefully remove the harness, clean and set aside. |