crwdns2933803:04crwdne2933803:0
crwdns2933797:0Alex Diaz-Kokaislcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alex Diaz-Kokaisl
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Soften the adhesive |
|---|---|
| + | [* black] Position the tip of the heat gun 2–3 inches above the device. |
| + | [* icon_note] The exposure time may change depending on the adhesive, temperature, and the distance between the heat gun and the device. |
| + | [* black] Move the heat gun along the area where the adhesive is located. |
| + | [* icon_caution] Always keep the heat gun in motion, and never leave it over one spot for too long—doing so could damage the device. |
| + | [* icon_note] If the adhesive that needs softening is small, still keep the heat gun in motion, moving it around in little circles. |
| + | [* icon_note] Some adhesives require multiple heating and prying cycles in order to loosen. Be patient to get the job done correctly and not quickly. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0