crwdns2933803:03crwdne2933803:0
crwdns2933797:0Alex Diaz-Kokaislcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alex Diaz-Kokaisl
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Turn on the heat gun |
|---|---|
| + | [* black] Turn on the heat gun. |
| + | [* icon_note] While heat guns can reach temperatures up to 1000 °F and higher, softening adhesives for electronics only requires a maximum of 300 °F. This can easily be achieved with the heat gun's low to medium-low setting. |
| + | [* icon_caution] Always start with the heat gun's lowest flow speed and temperature settings to avoid overheating the device you're working on. |
| + | [* icon_note] If your heat gun has fine control over the temperature, keep it in the mid-to-low range. Anything higher could deform plastic or damage internal components. |
| + | [* icon_caution] When not in use, set the heat gun on a stable surface. The nozzle will remain hot after use. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0