crwdns2933803:02crwdne2933803:0
crwdns2933797:0Student4Lifecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Student4Life
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Remove the Pedals | |
| [* black] To change the inner tube or tire, you will need to remove both pedals | |
| [* black] Use a 4mm Allen/Hex wrench to loosen the screw in the pedal hanger pillar. You will need to remove it to apply Loctite prior to reassembly. Turn counterclockwise to loosen. | |
| [* black] Use a 5mm Allen/Hex wrench to remove the two screws that capture the hinge pin. Turn counterclockwise to loosen. | |
| [* icon_note] One of the screws was difficult to turn. I slipped the handle of a "four-way screwdriver" over an Allen wrench for comfort and leverage. | |
| + | [* icon_caution] Avoid causing tool scaring on the end of the hinge pin. The pedals are held folded by a Teflon surface compressed against the end of the hinge pin. |
| [* black] Insert a hex wrench at one end of the pedal to push the hinge pin out far enough that you can pull the pin out by hand. | |
| [* icon_note] (in the photo, you are noticing that I taped some baby-proofing to the underside of the pedal) |