crwdns2933803:01crwdne2933803:0
crwdns2933797:0Spencer Daycrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Day
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Unfasten the MagSafe port | |
| - | [* red] Use a T2 Torx driver to ***loosen*** the two set screws in the frame that align the MagSafe port. |
| - | [* icon_note] Don't remove these screws. Just loosen them a few turns above the frame. |
| - | [* icon_note] Depending on the condition of your driver, a T3 Torx bit might fit best. |
| - | [* orange] Use your T5 Torx driver to remove the two 2.7 mm-long 5IP Torx Plus screws securing the MagSafe port. |
| + | [* red] Use a 2IP Torx Plus driver to ***loosen*** (don't remove) the two MagSafe Port set screws a few turns above the frame. |
| + | [* icon_note] In a pinch, you can use a standard T2 Torx driver to loosen these screws. Make sure to apply constant, downward force to prevent stripping. |
| + | [* orange] Use your T5 Torx driver to remove the two 2.7 mm-long screws securing the MagSafe port. |
| [* icon_note] These screws are not magnetic—be careful not to lose them. |