crwdns2933803:05crwdne2933803:0
crwdns2933797:0MeepleMecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 MeepleMe
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Remove Left Side Panel | |
| [* black] The left side panel needs to come off next in order to get the front and back panels off next. This is kind of weird, since removing it doesn't actually give you access to much mechanically. | |
| [* black] From the top of the machine, remove the three screws at the back left corner of the printer. | |
| - | [* black] Inside the printer, there are two black screws running vertically that attach the left panel to the front panel. Remove these. |
| + | [* black] Inside the printer, there are two black phillips head (+) screws running vertically that attach the left panel to the front panel. Remove these. |
| [* black] Still inside the printer, you'll see three black screws attaching the left panel to the floor plate, each with a small washer. THESE ARE HEX HEADS, not phillips. But DO NOT REMOVE THESE SCREWS! You can just loosen them, but leave them attached so they're harder to lose. | |
| [* black] At the bottom outside edge of the left panel, there are six push clips running horizontally that you'll need to disengage by pressing a flat head screwdriver against the base of each. | |
| [* black] On the back panel, at the back left corner of the printer, there are four more push clips running vertically to disengage. | |
| [* black] The panel should now pull away from the printer. |