crwdns2933803:03crwdne2933803:0
crwdns2933797:0MeepleMecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 MeepleMe
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] OPTIONAL Remove Top Window | |
| [* black] At the top of your printer is a transparent plastic window. It's only held in by flat tabs, no screws or push clips. There are 5 tabs at the front edge, and 5 tabs at the back edge. So open the front door, hold the window with a hand on each side of the pane, and pop it out. | |
| + | [* black] If it's really stuck, you can try prying it out with a flat head screwdriver, but be very careful of scratching the window pane or the case. Protecting them with masking tape is a good idea. |
| [* black] This is optional for a full teardown, since it's not necessary in order to get the top panel off, but it's handy for accessing your extruder in less dire situations. |