crwdns2933803:07crwdne2933803:0
crwdns2933797:0iRobotcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 iRobot
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Remove top PCB and plastic enclosure | |
| [* green] Heat up this PCB with either iOpener or a heat gun on low temp (100-120 Celsius) to loosen the adhesive and pry it off from the side. | |
| [* yellow] Remove the screws. | |
| [* red] The last screw is under a tamper-proof sticker | |
| - | [* violet] Use plastic spudger or tweezers to disconnect the camera flex cable from the top |
| + | [* violet] Use plastic spudger or [product|IF145-020|tweezers] to disconnect the camera flex cable from the top |
| [* icon_caution] Gently lift up the plasctic cover from the right side. It is still connected to the board below! | |
| [* blue] Disconnect the flex cable | |
| [* light_blue] Disconnect the antenna |