crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Richardcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Richard

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Using a Flat Head 2.5 unscrew and remove the four screws from the bottom of your Furbo; the four marked in red were the ones previously covered by the rubber caps. They are .05mm in length.
-[* orange] Remove the fifth screw, marked in orange, that is covered by a silver sticker. Use a Flat Head 2.5 screwdriver. This screw is also .05 mm in length.
+[* red] Use a 2.5 mm Flathead screwdriver to remove the four .05 mm screws from the bottom of the Furbo.
+[* orange] Use a 2.5 mm Flathead screwdriver to remove the single .05 mm screw under the silver sticker.