crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Connorcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Connor

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Use the nut driver to screw the screws into the four indentations previously made.
- [* icon_note] Be sure to sweep the metal shavings produced by this step before passing to the next one.
+[* black] Use a 1/4" nut driver to drive the screws into the four indentations.
+ [* icon_note] Be sure to sweep up and dispose of the metal shavings before moving on.