crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Connorcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Connor

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Place the center punch on one of the circles you made before.
-[* black] Take the rubber mallet and lightly hit the top of the center punch to make an indentation in the dryer door.
-[* black] Repeat this process for each of the circles marked (four times).
-[* icon_caution] CAUTION: Be very careful where you put your hand holding the center punch; make sure that it is not exposed to the rubber mallet.
+[* black] Place the point of the center punch in the middle of the marks you made before.
+[* black] Take a rubber mallet and lightly hit the top of the center punch to make an indentation in the dryer door.
+[* black] Repeat this process for the other three marks.
+[* icon_caution] Be aware of hand placement when holding the center punch; make sure that it can't be accidentally struck by the mallet.