crwdns2933803:02crwdne2933803:0
crwdns2933797:0Kris Rodriguezcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kris Rodriguez
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Open camera seal | |
| - | [* icon_caution] This step requires significant force, and has a chance of damaging your device. It |
| - | [* icon_note] If |
| + | [* icon_caution] This step requires significant force, and has a chance of damaging your device. It takes around 10-minutes of creating gaps and prying to get it off. Perform at your own risk! |
| + | [* icon_note] If confused with this step, ++please++ watch the video to see how it was performed. |
| [* black] Carefully insert an iFixit "Jimmy" Tool (flat flexible steel blade) between the hard white plastic housing and edge of the LED light ring. | |
| [* black] Pry the "Jimmy" tool slightly sideways and insert an iFixit "Metal Spudger" into the gap created. Slide it down inside the housing around half an inch. | |
| [* black] Use the metal spudger to pry carefully slowly working your way in a circle around the LED Light ring to attempt to slowly work it backwards out of the housing. | |
| - | [* |
| - | [* |
| + | [* icon_note] There is glue holding down the led light ring, so it might take some decent force to pry it, (see third photo). |
| + | [* icon_note] The LED Ring is sealed in place tightly using a rubber gasket, (see photo in next step). |