crwdns2933803:02crwdne2933803:0
crwdns2933797:0Sky Youngcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sky Young
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove the LED Ring |
|---|---|
| + | [* black] Carefully insert an iFixit "Jimmy" Tool (flat flexible steel blade) between the hard white plastic housing and edge of the LED light ring. |
| + | [* black] Pry the "Jimmy" tool slightly sideways and insert an iFixit "Metal Spudger" into the gap created. Slide it down inside the housing around half an inch. |
| + | [* black] Use the metal spudger to pry carefully around different locations on the LED Light ring to attempt to slowly work it backwards out of the housing. |
| + | [* black] Note: There is glue holding down the led light ring, so it might take some decent force to pry it (See third photo) |
| + | [* black] Note: Take care prying as there are three ribbon cables attached to the led light ring. Two for microphones, and one for the status LED. They are connected at the Camera Module and the components are lightly attached using some double-sided tape to the LED Light Ring. |
| + | [* black] The LED Ring is sealed in place tightly using a rubber gasket. (See second photo) |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0