crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Ian Hagoodcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ian Hagood

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Place the door panel on a chair to prop it up on a surface. Make sure to not disconnect wiring as it is not necessary to do such.
[* icon_caution] There may be circumstance where wiring could disconnect from the door. Take pictures of where the wires are located to keep track of how wires or chords are connected from the panel to the door.
[* black] Drill holes into two locations: the top holes and bottom holes pointed at.
-[* black] The size drill bit recommended is a 5/16 inch, but a 1/4 inch will suffice. Make sure to go all the way through so the new inner handle will fit in place.
+[* icon_note] The size drill bit recommended is a 5/16 inch, but a 1/4 inch will suffice. Make sure to go all the way through so the new inner handle will fit in place.