crwdns2933805:0crwdne2933805:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Remove the jumper and press the reset button on the board |
|---|---|
| - | [* black] s |
| - | [* black] ls /dev/serial/by-id |
| - | [* black] Select Save & Restart |
| + | [* black] Make sure you're in the klipper directory |
| + | [* black] cd ~/klipper/ |
| + | [* black] Enter the following commands |
| + | [* black] sudo cp "./scripts/klipper-mcu-start.sh" /etc/init.d/klipper_mcu |
| + | [* black] sudo update-rc.d klipper_mcu defaults |
| + | [* black] make clean |
| + | [* black] make menuconfig |
| + | [* black] Micro-Controller Architecture > Linux Process. Press esc than Y |