crwdns2933803:013crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Uploading Config Files | |
| - | [* black] You'll see Klippy-State error because printer.cfg isn't loaded. Upload printer.cfg, macros.cfg and moonraker.conf from my [link|https://github.com/armysolo/BLV-Cube/tree/main/Firmware/Klipper%202x%20Independent%20Z%20Fysetc%20Cube%20Spider%20v2.2|github]. |
| - | [* black] Place a jumper on BT0 and 3.3v and press the reset button to put the board into DFU mode. |
| - | [* red] SSH back into your pi. You'll need the SN from lsusb. Run the following command. Make sure you notate the entry for DFU mode. |
| - | [* black] lsusb |
| - | [* black] Run |
| - | [* black] cd ~/klipper |
| - | [* black] make flash FLASH_DEVICE=####:#### |
| - | [* black] Remove the jumper and press the reset button on the board. |
| + | [* black] In your web browser you'll see Klippy-State error because printer.cfg isn't loaded. Upload printer.cfg, macros.cfg and moonraker.conf from my [link|https://github.com/armysolo/BLV-Cube/tree/main/Firmware/Klipper%202x%20Independent%20Z%20Fysetc%20Cube%20Spider%20v2.2|github]. |
| + | [* black] Make sure you update line #40 with your device's serial ID |