crwdns2933803:014crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Building Fysetc Spider Firmware 4 |
|---|---|
| + | [* black] You should see the Flash light blink for a couple of seconds. I've had it take about 5 seconds but this time it literally took about 2. |
| + | [* black] Power off the board. You can verify the firmware uploaded successfully by inserting the SD card back into your PC. The binary file will be named old.bin. |
| + | [* black] Next insert your stepper drivers and plug in all the wiring. Make sure you have the connector for the stepper power connected. If you don't have the jumper wire or the 48v connector depending on your setup when 24v is applied to the board you can blow your stepper drivers. |
| + | [* black] Power on your Pi and Spider. If you're using 48v for your stepper drivers make sure the 48v PSU powers on with your 24v PSU |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0